We accept
FOLLOW US

Solacoat Heat Reflective Non-Slip Pavement Clear Sealer:

Description

Solacoat's Pavement Clear Sealer is a new technology, water based coating specifically designed to provide a clear sealed surface to the Solacoat Heat Reflective & Non Slip Waterproof Pavement Coatings to permit easy removal of surface dirt and oil stains in light vehicle traffic areas and parking lots. This system can be used on low speed, heavy vehicle areas also.

Features

  • Excellent adhesion to correctly prepared substrates
  • One pack convenience.
  • Rapid drying
  • Water based coating system – environmentally friendly
  • Does not alter the excellent non-slip characteristics in either wet or dry conditions of the Solacoat Pavement Coatings.
  • May be used indoors or outdoors.

Application

Pedestrian areas/Light Vehicle Traffic Areas

For very heavy pedestrian foot traffic and/or light, low speed vehicle traffic Solacoat Clear Sealer for Solacoat Pavement coatings must be applied to assist in spoilage removal for black heel marking, tyre marking and potential oil droppings. Regular cleaning of affected areas may be required so as to maintain maximum heat minimisation benefits.

NOTE:  None of these coatings will upgrade a low performance substrate to a high performance surface suitable for traffic/usage conditions more than what the original substrate was designed for. The substrate and foundation bases must be capable in design and condition to support the perceived usage traffic requirements.

NOTE:  Do not apply coatings to hot surfaces. Surfaces above 40ºC (or where the back of one’s hand cannot be rested comfortably on the surfaces for at least 20 seconds) are too hot for coating. Cracking or other coating problems may arise if application is made to hot surfaces or where excessive windy conditions during application and drying occur.

 

Coverage

Pedestrian/ light vehicle traffic areas

Solacoat Heat Reflective & Non-Slip & Waterproof Pavement Coatings:          approximately 2½ - 3 m2 / litre

Solacoat Heat Reflective & Non-Slip & Waterproof Pavement Clear Sealer:    approximately 4 – 7 m2 / litre

Allowance to be made for surface irregularities and application loses.

 

Drying

  • Touch dry:  Approximately 40 minutes

Solacoat Pavement coatings may be walked on after 24 hours and subjected to low speed, light vehicular traffic after 3 days under good drying conditions. Heavy vehicles i.e. large trucks, planes etc subject to low speed traffic after 7 days under good drying conditions.

 

Solacoat Heat Reflective Non-Slip Waterproof Pavement Clear Sealer Description Sheet

Solacoat Pavement Clear Sealer MSDS